2006 Suzuki Forenza - AT Fluid - Vehicle Specific
Transmission fluid is the lubricant for all the moving parts that make up your vehicle's transmission. Due to the heat generated in the transmission, the fluid can break down over time. What type of transmission fluid you need depends on your vehicle. Your car's manual provides transmission fluid service requirements. Regular transmission service is necessary to keep your car on the road. That's why O’Reilly Auto Parts has the transmission fluid your vehicle needs. Check out our complete line of products.Show More Show Less
How do you check the transmission fluid in a Suzuki Forenza?
Checking the Manual Transmission Fluid Level
- Park the Forenza on a flat surface and engage the parking brake.
- Crawl beneath the vehicle and locate the transmission check-and-fill plug on the driver’s side of the transmission, just behind the drive axle.
How can you tell if your transmission fluid is low?
Sudden up and down shifts, spikes in RPMs before shifting, strange grinding noises, and erratic shifts are also characteristics of this problem. All of these symptoms indicate you’re low on transmission fluid and at risk of overheating.
How do you check the transmission fluid on a 2005 Suzuki Verona?
With the engine running in PARK, remove this plug. If trans fuild doesn’t run out of the hole, the level is low. Pour it in the hole on top (where the red cap is) until the fluid runs out – all while the car is running. Once it is roughly dribbling out, the trans is considered full.
How do you check the transmission fluid on a 2004 Suzuki Forenza?
There is no dipstick to check the automatic transmission fluid in the 2004 Suzuki Forenza. It is checked like a manual transmission. You will have to remove the fill plug underneath the car and then add some new transmission fluid until it drizzels out of the hole.
How do you check the transmission fluid in a Suzuki Verona?
How do you check the transmission fluid on a 2007 Suzuki Forenza?
To check the level, you remove the side plug and check that the fluid is up to the bottom of the hole. This should be done with the fluid warm, but not too hot. The car needs to be level. It is most easily accomplished with the car on a lift or up on jack stands.
How do you check the transmission fluid on a 2007 Suzuki XL7?
How do you check the transmission fluid levels in a 2007 suzuki XL7? The dipstick – if you want to call it that, is down down down on the front of the transmission. It has a yeollow handle on it. You have to unscrew a 10mm bolt first that locks it in place, and then pull the stick out.
How do you check the transmission fluid on a 2006 Suzuki Reno?
In order to check the transmission fluid, your vehicle likely has check valve on the bottom of the transmission on the bottom of your car. Your car must be level when the fluid is checked and we therefore recommend having a mechanic with a hydraulic lift or underground bay check your transmission fluid.
What happens if I drive without transmission fluid?
Low-quality transmission fluid – or driving without transmission fluid altogether – can cause a number of problems such as transmission failure, gear slipping, a hard time shifting, and a few more issues. We can let you know if it’s a transmission flush you need or some other form of maintenance.
How long can u drive without transmission fluid?
However, unlike oil changes which need to happen much more frequently, you can usually postpone transmission flushes anywhere from 50,000 miles to 100,000 miles – or even 150,000 miles in some cases.
Pentosin 1058206 ATF-1 Synthetic AutomotiveTransmission Fluid, 5 Liter
Valvoline Multi-Vehicle (ATF) Full Synthetic Automatic Transmission Fluid 1 QT
Lubegard 60902 Automatic Transmission Fluid Protectant, 10 oz.
LUBEGARD Lube Gard Automatic Transmission Fluid ATF Synthetic Additive Red 60902 3 pack
Lubegard 69032 Complete Full Synthetic Automatic Transmission Fluid - 32 oz.
LUBEGARD Lube Gard Automatic Transmission Fluid ATF Synthetic Additive Red 60902 6 pack
ATP Automotive AT-216 Premium Synthetic Multi Vehicle ATF
Idemitsu (10107-042F OE Fluids Grey Automatic Transmission Fluid - 1 Quart
LUBEGARD Lube Gard Automatic Transmission Fluid ATF Synthetic Additive Red 60902 12 pack
Lubegard 23232 Complete Synthetic Power Steering Fluid, 32 fl. oz.
How to Check the Transmission Fluid in a 2006 Suzuki Forenza
Suzuki released its compact sedan, the Forenza, in the 2004 model year, and its production lasted through the 2008 model year. The 2006 model year Forenza came in two trim levels, Base and Premium, both of which came standard with a 126-horsepower, 2.0-liter engine and a five-speed manual transmission; both trim levels also had the option of adding in a four-speed automatic transmission in the manual's place. Neither of the Forenza's available transmissions have a dipstick to check the fluid level -- you must check it via a check-and-fill plug on the transmission.
Checking the Automatic Transmission Fluid Level
Drive the Suzuki for about three miles to circulate the fluid through the transmission, then park the vehicle on a level surface. Place the vehicle in "Park," engage the parking brake and leave the engine running.
Raise the front of the Forenza off the ground, using a floor jack, and position jack stands under the Forenza's subframe. Lower the Suzuki onto the jack stands.
Crawl under the vehicle and locate the transmission fill plug on the passenger's side of the transmission, under the drive axle.
Set a drain pan under the fill plug and remove the plug, using a ratchet and Suzuki tool No. DW260-070. If fluid flows from the hole, the level is correct. If fluid does not flow from the filler hole, add automatic transmission fluid ESSO LT71141, using a flex-neck funnel, until it flows from the filler hole.
Clean the fill plug with a clean, lint-free cloth and hand-tighten it into the filler hole. Tighten the fill plug to 33 foot-pounds, using a torque wrench and Suzuki tool No. DW260-070.
Raise the Suzuki off the jack stands, using a floor jack, and remove the jack stands. Lower the vehicle to the ground.
Checking the Manual Transmission Fluid Level
Park the Forenza on a flat surface and engage the parking brake. Raise the front of the vehicle, using a floor jack, and position jack stands under the subframe. Lower the Forenza onto the jack stands.
Crawl beneath the vehicle and locate the transmission check-and-fill plug on the driver's side of the transmission, just behind the drive axle.
Position a drain pan under the check-and-fill plug and remove it, using a ratchet and socket. Insert your finger in the hole and feel for the transmission oil. The correct level of the oil is at the base of the check-and-fill hole.
Cut the end of the nozzle off a bottle of SAE 80 transmission oil, using a utility knife, and insert the nozzle into the check-and-fill hole, if the level is low. Squeeze the bottle to start the flow of oil into the transmission. Repeat this step until oil flows from the check-and-fill hole.
Clean the check-and-fill plug with a clean, lint-free cloth and hand-tighten it into the transmission. Tighten the check-and-fill plug with a ratchet and socket -- take care not to over-tighten the plug.
Raise the Forenza off the jack stands, using a floor jack, and remove the jack stands. Lower the vehicle to the ground.
Things You'll Need
- Floor jack
- Jack stands
- Drain pan
- Suzuki tool No. DW260-070
- Automatic transmission fluid ESSO LT71141 (amount varies)
- Flex-neck funnel
- Clean, lint-free cloths
- Torque wrench
- Socket set
- SAE 80 transmission oil (amount varies)
- Utility knife
Justin Cupler is a professional writer who has been published on several websites including CarsDirect and Autos.com. Cupler has worked in the professional automotive repair field as a technician and a manager since 2000. He has a certificate in broadcast journalism from the Connecticut School of Broadcasting. Cupler is currently studying mechanical engineering at Saint Petersburg College.
More ArticlesSours: https://itstillruns.com/check-fluid-2006-suzuki-forenza-8725779.html
Fluid transmission 2006 forenza suzuki
Transmission Fluid Level Check Suzuki Forenza (2004-2008)
Our research indicates that your vehicle does not have a transmission fluid dipstick. These types of transmissions are designed to be maintenance free. In order to check the transmission fluid, your vehicle likely has check valve on the bottom of the transmission on the bottom of your car. Your car must be level when the fluid is checked and we therefore recommend having a mechanic with a hydraulic lift or underground bay check your transmission fluid. Any fluid leaks for this type of transmission should be treated by a mechanic.
Hans Angermeier has produced over 100,000 videos showing drivers how to fix things on their cars. He has broad expertise on basic repair procedures covering the majority of cars on the road.
Want an easy way to save $500? Rotate your tires at least three times per year
Did you know that the sun wears out wiper blades faster than rain? Replace your blades twice a year
If your car blows hot air when your air conditioner is turned on, try recharging the freon first
Don't be the guy with your third brake light burnt out
DW260-070 Transaxle Fluid Plug Remover/Installer
Start the engine and allow the engine to idle for approximately 5 minutes , or, if possible, drive the vehicle for afew kilometers (miles) to warm the transaxle fluid. Check the fluid level when the transaxle is over 30 C (86 F).
Press the brake pedal and move the shift lever through the gear ranges, pausing a few seconds in each range. Return the shift lever to the park position. (Left-Hand Drive Shown, Right-Hand Drive Similar.)
Raise and suitably support the vehicle.
Place a fluid container below the fluid level plug.
Remove the fluid level plug using the plug remover/installer DW260-070. Because the transaxle operates correctly over a range of levels, fluid may or may not drain out of the plug hole when the plug is removed.
Check the oil fluid level. If fluid does not drain through the plug hole after adding a total of 4 liters, then the transaxle was either underfilled or the transaxle is leaking fluid. Inspect the transaxle for fluid leaks. Fix any leaks before setting the transaxle fluid level.
Install the fluid level plug using the plug remover/installer DW260-070. Tighten: Tighten the Fluid Level Plug to 45 Nm (33 ft. lbs.) .
When the fluid level checking procedure is completed, wipe any fluid from the transaxle case with a rag or shop towel. Also, check that the fluid fill cap and the vent tube are properly installed.
Monday, February 15th, 2021 AT 1:21 PM (Merged)
You will also be interested:
- Jurassic park you tube
- Jp morgan real estate jobs
- 2019 chevy silverado accessories ebay
- Home depot cabinet paint
- Burleigh county nd property search
- Non slip shelf liner
- Trainer tire 700 x 32
- Husqvarna 46 inch mulching kit
- Tower 24 santa monica
- What is a telescoping flagpole
2006 Suzuki Forenza OilsR.Us - Only the Best!
Suzuki Motor of America, Inc.
|NHTSA ID: |
|Recall Date: |
May 19th, 2014
|Units Affected: |
Affected Component: Exterior lighting:headlights.
Summary: Suzuki motor of america, inc. (suzuki) is recalling certain model year 2004-2008 forenza vehicles, and 2005-2008 reno vehicles manufactured from september 1, 2003, through july 30, 2008. In the affected vehicles, heat may be generated in the headlamp switch or daytime running light (drl) module which could melt the headlamp switch or the drl module. .
Conequence: If the heat generated within the headlamp switch or drl module located on the left side of the steering column melts the headlamp switch or drl module, there is an increased risk of a fire. .
Remedy: Suzuki will replace the signal switch and add a jumper relay kit and will replace the drl module in teh instrument panel harness. Suzuki distributed to owners an interim letter on july 30, 2014. The recall began october 29, 2014. Owners may contact suzuki at 1-800-934-0934. Suzuki's number for this recall is xa. .
Notes: Owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153).